Tip of the Week - Knitting Machine Lighting Fixture



Good lighting is essential for machine knitters. Here is an inexpensive lighting fixture for over your machine. Customize it for your setup and room and you'll have a portable, easy-to-assemble light. Includes part list and assembly instruction.
Click Here to view
the Tip of the Week
Click here to view previous Tips
Posted by Sue Jalowiec on 02/28/2013 at 5:46 AM | Categories: Machine Knitting Tutorials -

1 Comments

Victoria

Victoria wrote on 11/06/14 2:19 PM

If you have any folks that are putting this on a hard surface floor like wood or concrete, and comment that it rocks a little, its because the center "T" causes there to be a little height difference. Simple solution. There are pipe end caps that can go on the ends of the open pvc, which will match the height of the "T" joint. Caps available in the same section of the hardware store as the T's. For folks on carpet, the height differences won't be noticeable.

Write your comment


(it will not be displayed)